化学计量泵，基于微处理器，高性能

PHP-200 Series

查看下面所有型号

下单

Continuous Stroke Length Adjustment Measured
Direct Calibration and Built-In Warning
Adjustable Back-Pressure Control
Totalized Output in U.S. Gallons or Liters
Bleed Valve Standard
Control Options: Manual or Analog
Relay Output Option
Available In Polypropylene, PTFE or Stainless Steel Liquid Ends

产品描述

The PHP-200B series has been discontinued. Please see the PHP300/400/500 Series as a possible alternative or contact our Flow Engineering department.

The PHP-200B Series is a diaphragm-type, solenoid driven microprocessor based metering pump with maximum capacities to 4.5 gph and maximum back pressures to 253 psig. The housing is constructed of fiberglass-reinforced PPE plastic, with a NEMA 4X (IP65) enclosure rating to protect against corrosion, dust and water. A removable hood covers the faceplate. The drive unit houses a short-stroke solenoid with a maximum stroke length of 1.25 mm (0.05"). It is equipped with a noise suppressing mechanism for quiet operation and has only one moving part, the armature. The diaphragm is constructed of fabric-reinforced EPDM elastomer with a plastic core and PTFE facing. It is chemically resistant against virtually all process fluids and can be used over a wide temperature range. Suction and discharge ports are equipped with double ball check valves for maximum repeatability. Feed rate is determined by stroke length and stroke rate. Stroke length is manually adjustable from 1 to 100% in increments of 1% via the stroke length knob. Two control modes are available for the PHP-200B Series: manual or analog control.

The PHP-210B Series incorporates all the features of the PHP-200B and also accepts a current input signal. This allows the stroking rate to be controlled by standard process signals.

SPECIFICATIONS
    Maximum Stroke Length: 1.25 mm (0.05")
    Materials of Construction:
    Housing: Fiberglass-reinforced PPE
    Diaphragm: PTFE-faced EPDM with plastic core
Liquid-End Options: Polypropylene (P), PTFE (T), 316 SS (S)
Seal: FKM for P models, PTFE for T and S models
Enclosure Rating: NEMA 4X (IP66)
Power Supply: 100 to 230 Vac, 1 phase, 50/60 Hz ±10%
Repeatability of Metering: ±2% under constant conditions and at minimum 30% stroke length
Ambient Temperature Range: -10 to 45°C (14 to 113°F) Max Fluid Operating Temperature: 50°C (122°F)
Power Cord: 2 m (6')

† 所有金额以RMB显示
注: Each unit is supplied with foot and injection valves, 1.8 m (6') of contact cable for pulse input, and level connector.
Polypropylene models are supplied with a 3 m (10') or 1.5 m (5') length polyethylene tubing.
† Capacities and suction lifts are for water-like fluids. Higher specific gravity fluids reduce suction lift, while higher viscosity fluids reduce capacity.
* “-S” pumps have 1/4" FNPT connections.